ALISADO 33 Lo Mejor

The Best or The Best Coco or The Best Acai
1. pH+ Clarifying Shampoo The application starts with washing the hair twice with GK Hair pH+ Clarifying Shampoo. The clarifying shampoo preps the hair for the Juvexin treatment and removes excess build up and styling products from the hair. Towel dry and brush the hair.

2. Apply "THE BEST" Section the hair in 1/2-inch each and use the application brush to apply “The Best” on each 1/2 -inch section of hair. DO NOT APPLY ON THE SCALP. Be sure to stay 1/4-inch away from the scalp while combing or massaging the product through the hair. Be generous with the strokes as all of the hair needs to be saturated in order for the treatment to have maximum effect.

3. Let sit for 40-60 min. Allow the product to sit on the hair for 40 to 60 minutes, cover the hair with a plastic cap. a) 40 minutes for fine, wavy hair b) 60 minutes for thick, coarse, tight curly hair to maximize the smoothing results.

4. Rinse the hair with warm water until the products runs clear out of the hair. If hair is over-processed or red, shampoo the hair with GK Hair Moisturizing Shampoo focusing on the ends to remove excess product.

5. Apply the Deep Conditioner and rinse off after 5 minutes.

6. Blow dry on high heat Blow dry the hair straight on high heat with a round brush using sufficient tension to smooth the hair until 100% dry.

7. Sealing Section the hair and flat iron with GK Hair Titanium Flat iron at 400 degrees. If the hair is over processed, flat-iron at 375 degrees, lower the temperature further if the hair is very weak and damaged; especially towards the ends of the hair. Pass the flat iron about 2-4 times on each section.

8. Once the treatment is complete, individuals can freely resume their regular hair care routine, including washing their hair at any desired time using GK Hair Shampoo and Conditioner infused with Juvexin. This will help maintain the results achieved from the treatment.

Deep Conditione
Wash your hair, and apply the Deep In Conditioner to your hair. Leave it on for 20 minutes and then rinse thoroughly for super conditioned hair.

pH+ Shampoo
Apply to wet hair, massage into hair and lather. Leave on the hair for 1-3 minutes. Rinse and repeat up to 2 additional times for virgin hair when following with a GK Hair treatment.

Moisturizing Shampoo & Conditioner
Lather, massage, and rinse. Repeat with Moisturizing Conditioner for soft and sleek hair.

Serum
Apply on clean, dry or damp hair after washing with shampoo and conditioner. Work the Serum into your ends up to mid-hair length and feel your flyaways and frizz instantly disappear.

Balancing Shampoo & Conditioner
Lather, massage, and rinse. Repeat with Balancing Conditioner for smooth and shiny hair.

Vegan Shampoo & Conditioner
Lather in Vegan Shampoo, massage, and rinse. Repeat with Vegan Conditioner for soft and sleek hair.

D700 Flate Iron
Take extra care when using this flat iron as it gets very hot. To prevent your hair from over drying or damage, it is important to establish the correct temperature before using the iron. If in doubt, start with the lowest temperature setting and increase the heat gradually as required. For fine hair, use a lower temperature setting, and for thick hair, use a higher temperature setting.

1. Place your flat iron on a flat, hard, heat resistant surface. Plug into the power outlet (100AC or 240AC) and slide the on/off button to switch on your flat iron. Select the desired temperature by scrolling the dial forward or backword.
2. Your hair iron is ready for use in one minute, depending on the temperature selected. It takes approximately 3 minutes to reach the highest level of temperature.
3. To make styling easier, use clips to section your hair, on top, sides and back.
4. Start straightening from the nape of your neck, continue around to each side and finish with the front section.
5. Take a small section of hair and starting at the roots, clamp it between the heating plates firmly.
6. Run the flat iron down through the entire length of hair from roots to tips without stopping.
7. Repeat until you achieve the desired results.
8. When finished, slide the on/off button to switch off the device and remove plug from the power outlet.
   

P: ¿Cuál es el procedimiento de solicitud de resistente?

R: Paso 1: Lave el cabello del cliente dos o tres veces con GK pH+ Clarifying Shampoo. Paso 2: Aplicar a 1/4 de pulgada de las raíces, masajear en cada sección y peinar para una distribución uniforme eliminando el exceso de producto del peine. Paso 3: Seque el cabello del cliente con secador hasta que esté 100% seco. Paso 4: Plancha para alisar y sellar las cutículas. El producto se debe dejar actuar sobre el cabello por un periodo de 48 horas. Durante este tiempo, es importante evitar cortar, tirar hacia atrás o trenzar el cabello. Transcurrido el periodo de 48 horas, se recomienda lavar el cabello siguiendo las instrucciones adecuadas proporcionadas.

P: ¿Debería haber un tiempo de espera después de la aplicación de resistente y secado del cabello?

R: No debería haber tiempo de espera: el secado con secador debe seguir al tratamiento inmediatamente.

P: ¿Cuál debe ser la temperatura para el cabello procesado con plancha? (Resistente)

R: La temperatura de la plancha debe ser de 375 a 420 grados Fahrenheit (180 a 230 grados Celsius). Sin embargo, según su criterio profesional, puede aumentar la temperatura a 450 grados Fahrenheit. También recomendamos utilizar planchas GK Hair Titanium Plate durante la aplicación de los tratamientos GK Hair Juvexin.

P: ¿Se puede dejar el tratamiento Miami Bombshell en el cabello como resistente/rizado?

R: Miami Bombshell tiene un proceso de aplicación diferente al de Resistente/Rizado y debe seguirse para obtener resultados óptimos. Paso 1: Lave el cabello dos veces con el champú GK Hair pH+ antes de la aplicación. Paso 2 Secciona el cabello. Paso 3 Aplique GK Hair Miami Bombshell uniformemente por todo el cabello con una brocha aplicadora. Asegúrese de que el tratamiento quede a 0,5 cm del cuero cabelludo. Retire el exceso de producto del cabello con un peine de púas finas. Paso 4 Cubra con una tapa de plástico y déjelo reposar durante 5 a 30 minutos bajo el calor. Paso 5 Enjuague hasta el punto en que el agua salga casi clara. Paso 6 Seque con cepillo redondo hasta que esté 100% seco. Paso 7 Plancha el cabello para sellar las cutículas. Paso 8 Lave el cabello con el champú GK Hair Silver Bombshell. Paso 9 ¡Peina como desees!

P: ¿Por qué hay que esperar hasta que se lave el cabello? (Para Resistentes O Rizados)

R: Recomendamos esperar porque Resistance tarda 48 horas en formar un vínculo más fuerte con la corteza del cabello. Si el cabello se lava inmediatamente después del tratamiento, es posible que parte o la mayor parte del tratamiento se elimine y que los resultados no duren tanto como se desea.