Steps to a Perfect Keratin Treatment:
Performing a keratin treatment at home involves following specific steps to ensure the treatment works effectively. From prepping your hair to the final post-treatment care, here’s how to achieve the perfect results using The Best Keratin Treatment of GK Hair. Let’s break it down step-by-step.
Step 1: Hair Cleansing
The first and most crucial step in any keratin treatment at home is cleansing your hair. Use pH+ Clarifying Shampoo to wash your hair twice. This shampoo removes product build-up, oils, and impurities, allowing the keratin treatment to penetrate the hair shaft effectively. Remember, skip the conditioner—clean, bare hair is key to achieving optimal results.
Step 2: Dry and Section the Hair
After cleansing, towel dry your hair to remove excess moisture. Use a blow dryer to ensure your hair is 100% dry, as wet hair can dilute the treatment. Once dry, use a comb to part your hair down the middle and divide it into four sections. This will help evenly distribute Keratin Treatment for consistent results.
Step 3: Apply The Best Keratin Treatment of GK Hair
Now it’s time to apply The Best Keratin Treatment. Using an application brush, take small ½-inch sections of hair and apply the treatment generously, staying about ¼-inch away from the scalp. Make sure to comb or massage the product thoroughly into each section to ensure every strand is saturated. This thorough application is crucial for achieving that smooth, shiny finish.
Step 4: Processing Time
After applying GK Hair’s "The Best" Keratin Treatment, it's time to let the product work its magic. Allow the treatment to sit in your hair for about 15 to 60 minutes. For fine or wavy hair, 15 minutes is sufficient, while thicker, coarser hair may benefit from the full 60 minutes. This waiting period is essential for the keratin to bond effectively with your hair.
Step 5: Rinse the Hair
Once the processing time is complete, it’s time to rinse your hair. Start by washing with warm water until the water runs clear, ensuring all excess treatment is removed. If your hair appears over-processed or has a red tint, use GK Hair Moisturizing Shampoo focusing on the ends. This step is crucial for preparing your hair for drying and styling.
Step 6: Dry the Hair
After rinsing, the next step is to dry your hair thoroughly. Use a blow dryer on high heat to dry your hair completely. For best results, utilize the GK Hair Thermal Round Brush to help smooth the hair as you dry. Ensuring your hair is 100% dry is essential for the next step, where you will flat iron the hair to lock in the keratin treatment.
Step 7: Flat Iron the Hair
The next step involves using a flat iron to seal in the keratin treatment. Section your hair again for easier handling and set your flat iron to 450 degrees Fahrenheit (400 degrees for over-processed hair). Slowly glide the iron through each section, ensuring you apply enough heat to lock in the treatment without damaging the hair. This step is essential for achieving that sleek, shiny finish.
Step 8: Post Treatment Care
After completing the keratin treatment, it's essential to follow proper post-treatment care for lasting results. Avoid tying your hair up for at least sometime to let the treatment fully set. For your first wash, wait 2-3 days, and then use GK Hair Shampoos and Conditioners, specifically formulated with Juvexin, to maintain your hair’s health. Also, avoid using hard water, as it can disrupt the protein layer created by the treatment.
Leave a Comment